Pump Control Panel (Alternating)

£380.00 (excl VAT)

Includes adjustable overload relays to allow setting to pump motor ratings and automatically turns off the corresponding pump should the rating be exceeded.  There is an automatic mode that turns on the first pump when the fluid level reaches control point 1.  Pump 2 starts when the fluid level reaches control point 2.  Both pumps will remain on until the fluid level drops to a stop control level. There is also a safety control that turns off the pumps to protect them should the levels get to a critically low point. Whenever the alarm control closes a buzzer and light will come on. There is also a manual mode that allows the pumps to be turned on and off as required.

SKU: TWINPUMP01 Category:

Description

Twin Pump Alternating Control Panel. Control and protection of water pumps used in pumping stations with 2 pumps. Pumps alternate over duty cycle controlled by AVEL alternating relay.

Additional information

Dimensions

30 x 25 x 14cm ABS plastic box

Power Requirements

230V 50Hz single phase or 400V 50Hz three phase.

Pump Overload Rating

1.8 to 2.8A / 2.8 to 4.0A / 4.0 to 6.3A / 5.6A to 8.0A / 7 to 10A / 8 to 12A

Specification

Contactor and overload relay.
Alternating and simultaneity control by (AVEL) alternating relay.
Buzzer and light alarms controlled by a 3 position toggle switch with rubber cap keeping the alarm in automatic, test or off mode.
Automatic, on or off mode system control for each pump.
Motor start/stop control connection with reduced tension (12v).
Safety control connection with reduced tension (12v).
Alarm control connection with reduced tension (12v).
Protection of the power circuit by a circuit breaker.
Protection of the power circuit against overloads.
Phase presence indication (yellow signal lamp).
Running motor individual indication (Green signal lamp).
Overload trip individual indication (Red signal lamp).
Running alarm indication (red signal lamp).
6 cable glands for connection cables.